LWMMS150 is controlled by relay, and uses imported temperature control equipment to control the temperature，the spot welding time is controlled by time relay，the magnetic stripe can be mounted on the covered film under the heating and pressure. It is available for mounting sheet material.
1. Use double cylinders as motivity，the pressure of the welding spot can be adjusted，the magnetic stripe welding spot is level off and firmed
2. Heating temperature control method: use the heater to heat up and the imported thermocouple cooperating with temperature controller to control the temperature，it is easy to set and the temperature controller is precise.
3. The spot welding time is controlled by time relay and the time can be adjusted as needed. It is simple and convenient for setting.
|Power source||AC 380V/50 HZ||Available material||0.25~0.8mm covered film sheet|
|Air source||6 kg/c㎡(no water)||Stripe type||Accord with ISO/IEC7811 high density and lower density magnetic stripe|
|Total power||3KW||Stripe width||12.7mm 6.35mm plate dia.380mm|
|Temperature control range||0-400℃(can be set)||Stripe amount||5~8 PCS|
|Temperature control precision||±2℃||Available sheet||3X8、4X8、5X5(with choice)|
|Laying precision||±0.2mm||Operator||1 person|